The Platform Ladder is a self-supporting portable ladder that is non-adjustable in length, with a platform provided at the highest intended standing level. It has a hinged design for ease of storage and is intended for use by one person. The top platform is surrounded on three sides by a railing that is at least 20 inches higher than the platform surface. A folding Bucket (Pail) Shelf may also be provided.
Platform Ladders range in size from 2 ft. to 18 ft. in length as measured from the bottom along the side rail to the top of the platform. The maximum work height is established by adding the user's height and reach to the highest standing level of the Platform Ladder.
A Platform Ladder requires level ground support for all four of its side rails. If this work site condition does not exist, a Platform Ladder should not be selected for the job.
A Platform Ladder must not be used unless its base is fully open and the Spreaders, locked. Platform Ladders are not to be used as Single Ladders or in the partially open position.
In order to prevent tipping the ladder over sideways due to over-reaching, the user must climb or work with the body near the middle of the steps or platform. The ladder should be set-up close to the work. Never attempt to move the ladder without first descending, relocating the ladder, and then re-climbing. Do not attempt to mount the ladder from the side or step from one ladder to another unless the ladder is secured against sideways motion.
When ascending or descending the ladder, always face the ladder and maintain a firm hold. Do not attempt to carry other objects in your hand(s) while climbing.
The braces on the rear of a Platform Ladder are not intended for climbing or standing and must not be used for that purpose.
The anti-slip feet at the bottom of the Platform Ladder side rails must be present and in good condition prior to using the ladder. The ladder must not be used on ice, snow or slippery surfaces unless suitable means to prevent slipping is employed.
A Platform Ladder must never be placed upon other objects such as boxes, barrels, scaffolds, or other unstable bases in an effort to obtain additional height.
A thorough inspection must be made when the ladder is initially purchased and each time it is placed in to service. Clean the climbing and gripping surfaces if they have been subjected to oil, grease or slippery materials. Working parts, bolts, rivets, step-to-side rail connections, and the condition of the anti-slip feet (safety shoes) shall be checked. If structural damage, missing parts, or any other hazardous defect is found, the ladder must not be placed in to service and either discarded or competently repaired.
Ladders exposed to excessive heat, as in the case of fire, may have reduced strength. Similarly, ladders exposed to corrosive substances such as acids or alkali materials may experience chemical corrosion and a resulting reduction in strength. Remove these ladders from service.
Ladders with bent or broken side rails must be destroyed.
In the event a ladder is discarded, it must be destroyed in such a manner as to render it useless. Another person must not be afforded the opportunity to use a ladder that has been deemed unsafe.
When transporting ladders on vehicles equipped with ladder racks, the ladders must be properly supported. Overhang of the ladders beyond the support points of the rack should be minimized. The support points should be constructed of material such as wood or rubber-covered pipe to minimize the effects of vibration, chafing and road shock. Securing the ladder to each support point will greatly reduce the damaging effects of road shock.
Storage racks for ladders not in use should have sufficient supporting points to avoid sagging which can result in warping the ladder. Other materials must not be placed on the ladder while it is in storage.
Platform Ladder Safety Standards
Safety requirements for Construction, Performance, Use and Care of Platform Ladders can be found in the following standards: